Handheld cutting
Fiber laser
CO2 laser
English [change]
Sensor PHC
- Share page
-
-
-
-
Overview
The Sensor PHC is an easy-to-use and reliable voltage-sensing height control for conventional plasma applications. The benefits realized are substantial in terms of:
- Consumable life improvement
- Improved cut quality
- Reduced operator intervention
The Sensor PHC offers easy installation on new or existing conventional plasma cutting tables with any CNC and a broad range of plasma systems. Available in several application-specific configurations, the Sensor PHC delivers improved performance at a reduced cost compared to other height control solutions.
Improved cut quality performance The Sensor PHC offers improved quality over the entire life of the consumables. The following cut-edge angle dimensions were measured at the beginning and end of a 450 pierce-and-cut test for both setups.
| 1st cut sample, maximum kerf angle |
451st cut sample, maximum kerf angle |
|
| No PHC | 4° | 11° |
| Sensor PHC | 3° | 4° |
| Angles were measured on all four sides, all four samples. The lower the number, the better the cut quality. The angles will vary with thickness | ||
Magnetic breakaway Tethered magnetic breakaway for consistent positioning during cutting and retention after collision or consumable change. Powerful magnets and keyed mounting plate for fast and repeatable repositioning of the torch.
Specifications
| Maximum speed | 5120 mm/m (200 ipm) |
| Range of motion | 150 mm (6") |
| Arc voltage set-point | 50 V – 210 V arc voltage set-point for arc-voltage feedback; accurate to 1 arc-volt |
| Ohmic contact and stall-force initial height sense | |
| On/off signal provided by CNC | |
| * Information subject to change without notice. ** User supplied display and keyboard are required |
|
Hypertherm dealer network
Hypertherm products are sold exclusively through our network of authorized partners. While different partners sell and service different products, in general, Hypertherm distributors sell the Powermax brand of air plasma products, as well as consumables for all types of Hypertherm systems; some distributors also sell automated products. Rental companies typically rent or lease Powermax air plasma products and may sell consumables for those systems. Table manufacturers / OEMs sell automated cutting products and consumables and typically offer service on what they sell. Systems integrators sell retrofits and upgrade products.
Visit our where to buy page to find a potential partner, or
contact Hypertherm directly if you need further assistance.
Customer reviews
Loading...Share your review
Please share your experience and help users like you choose a system that's right for them.
Thank you for sharing your review with us.
